Installing Recessed Ceiling Lights
Fish the cable use a fish tape reel to pull cables through joist spaces.
Installing recessed ceiling lights. Step 2 install recessed lighting. Connect the low voltage fixtures. When installing recessed lighting in an existing ceiling a hole is cut in the ceiling that exactly fits the profile of a special remodeling can to keep from damaging the surrounding drywall.
New construction housing should be used if the ceiling is accessible. Repeat this for each light fixture. How to install recessed lighting step 1.
Nail up standard new work housings in open ceilings. Drill a hole through the drywall ceiling at each light location using a drill and 6 inch diameter hole. For more lighting tips see our lighting and ceiling f.
However make sure that you don t tighten down any covers or install light bulbs until you finish the wiring. Once the basic housing is installed an inner sheath called a baffle is used to cover the bare metal can for a. The excess wire gives you enough slack to wire the new fixtures.
Slip the can s box into the hole and then push the can body up into the hole until its flange is tight to the ceiling. Choose locations that fall between joists and away from. New construction lights are.
Wire and then. If an attic is above the ceiling run the wire from the attic. The recessed lighting housing type you select is based on the type of installation you ll be doing.